Rogue-audio M-120 Bedienungsanleitung PDF herunterladen (Seite 12)

IF THERE IS A PROBLEM

Below is a checklist of possible solutions if any problems are encountered.

IF THERE IS NO SOUND

1) Check that all input and output signal connections are secure.

2) Ensure that all tubes are properly seated in sockets.

3) Ensure that power cord is seated securely.

IF SOUND DISTORTIONS ARE PRESENT

1) Ensure tubes are in proper locations. See Figure 3.

2) It is possible that a tube has gone bad. Return the unit to the

dealer to the dealer to test the tubes.

IF THERE IS A 50/60 Hz HUM

1) Make sure that both amps and the preamp are plugged into the

same outlet or power strip.

2) Use the circuit ground lift switch on the rear of one or both

amplifiers to break a ground loop.

3) Unplug all other equipment from the amps and work backwards

connecting the preamp, source, etc back in until the source of the

hum/ground loop is determined.

If these steps do not clear up the problem, please call Rogue Audio

Technical Support on 570-992-9901.

3) Remove Foam Packing – Carefully remove the foam from under

the tube cage at rear of chassis. It is important that you retain the

tube packing material in the event that the amplifier ever needs

servicing. See Figure 2.

Figure 2

Rogue M-120 Owners Manual 3

Rogue M-120 Owners Manual 10

Tube Cage

Foam packing

1 2 ... 7 8 9 10 11 12 13 14 15 16

Keine Kommentare

Rogue-audio M-120 Bedienungsanleitung Seite 12