Rogue-audio M-120 Bedienungsanleitung PDF herunterladen (Seite 10)

OPERATING YOUR AMPLIFIER

1) Powering up the system - First turn on the amplifier by pushing in

the “power” button. The red LED will light after several seconds

after which the unit is ready for use. Always turn on the

preamplifier in the system before the power amplifier and source

materials, and always turn off the power amplifier first

2) Breaking in the amplifier - As with many high-quality audio

amplifiers, the sound of the Rogue M-120 amplifier will improve

during the first few hours of use. This time is required for

components to “burn in.” No special techniques are required

other than standard operation.

3) Switching between ultralinear and triode operation - An

important feature of the M-120 monoblocks is that they can be

configured for operation in either triode or ultralinear mode. In

triode operation the amplifier will produce somewhat less power

but may offer a more appealing sound with some speaker/room

combinations. To switch operating modes, there is a switch on

the rear panel of each monoblock. If the amp is not switched off

a small and harmless switching noise will be heard when

switching from ultralinear to triode.

5) Matching Speaker Impedance - The Rogue M-120 provides

separate binding posts positions for both 4 ohm and 8 ohm

speakers, as shown in Figure 4. The impedance selected will

depend on the speakers used. Consult either the owner’s

manual for your speaker or your local dealer for the correct

choice.

Rogue M-120 Owners Manual 5 Rogue M-120 Owners Manual 8

Figure 4

8 Ohm Tap

4 Ohm Tap

Signal

Input

Power Main

Fuse

5 Am

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

Keine Kommentare

Rogue-audio M-120 Bedienungsanleitung Seite 10